Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!samsung!uunet!cpqhou!scotts
From: scotts@cpqhou.UUCP (Scott Shaffer)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Connecting VGA card to NEC Multisync monitor
Message-ID: <513@cpqhou.UUCP>
Date: 16 Jan 90 06:00:00 GMT
References: <7467@shlump.nac.dec.com>
Lines: 16


Can somebody help me figure this setup out?  I have an origonal Msync and
a Paradise VGA Plus in my Compaq 386.  The problem is that the monitor in
digital mode doesn't read the horizontal sync line correctly (hence the 
need to adjust the horizontal side in all modes) and it causes VGA modes
to be spread tall and EGA 640x350 mode to be short.  Its a mess and a
hassle.  My question is, does anybody know of a solution?  I talked to
NEC, and they said that a) it was thier fault, b) some additional hard
ware would be necessary, and c) they won't fix it, buy a Msync II.

So, does anybody know where I can find a way to fix this?

Scott Shaffer
Compaq Computer Corp.

(* These opinions are mine, and no one else's *)