Path: utzoo!utgpu!watserv1!watmath!att!cbnewsl!bonnie!prg
From: prg@bonnie.ATT.COM (Paul R. Gloudemans)
Newsgroups: comp.sys.mac
Subject: Re: Weird problem with VersaTerm 4.0
Summary: Not to panick!
Keywords: problem in MultiFinder
Message-ID: <3708@cbnewsl.ATT.COM>
Date: 17 Jan 90 23:22:19 GMT
References: <23269@ut-emx.UUCP>
Sender: nntp@cbnewsl.ATT.COM
Reply-To: prg@bonnie.ATT.COM
Organization: AT&T Bell Laboratories
Lines: 21

In article <23269@ut-emx.UUCP>, jay@ut-emx.UUCP (Jay Boisseau) writes:
> I just experienced a weird problem with VersaTerm 4.0.  I tried to launch it
> ... 
> I checked the Get Info box for VersaTerm, and, to my surprise, BOTH the
> "Suggested Memory Size" and "Application Memory Size" (in the little box) were
> listed as "n/a".  [Remaining stuff deleted.]
> 
> Does anybody know what might have caused this?  I'm a little concerned that
> something is trashing my software, but I have found no viruses.  Help!

The "n/a" in the "Suggested" and "Application" Memory Size boxes is
normal if Versaterm was running under Multifinder at the time you did
the "Get Info".  I don't have version 4.0 but previous versions were
not configured properly right from the shrink wrap for running under
Multifinder; had to increase the "Application Memory Size" allotted to
account for MF overhead.  I suspect that after you re-installed and
did the "Get Info" Versaterm was NOT running and thus the memory sizes
appeared "normal".

Just increase the "Application Memory Size" and Versaterm should run
properly under MF.