Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!tut.cis.ohio-state.edu!purdue!mentor.cc.purdue.edu!pur-ee!pur-phy!murphy
From: murphy@pur-phy (William J. Murphy)
Newsgroups: comp.sys.amiga
Subject: Re: Fonts - interlace, overscan
Message-ID: <3011@pur-phy>
Date: 21 Jan 90 06:13:06 GMT
References: <1052@lpami.wimsey.bc.ca>
Reply-To: murphy@newton.physics.purdue.edu.UUCP (William J. Murphy)
Organization: Purdue Univ. Physics Dept., W. Lafayette, IN
Lines: 20

>In article <5455.AA5455@caleb> jdp@caleb.UUCP (Jim Pritchett) writes:
>
>Has anyone out there found a good font for use on a interlaced, overscanned
>workbench screen?  I'm currently using topaz 11.  It looks ok, but what are
>you using for this case?  (I am new flicker fixer owner.)
>

I have been using f80 which was released with Meshugena.  Devine Corzine
may have been the one who created f80, he wrote Meshugena.  f80 cuts off
all of the little serifs in Topaz. The only character I really don't like
is the pipe character, |.  It looks exactly like l|, see what I mean.
Ha! Of course you can't... You're not using this font! HaHa HaHa.

(slightly maniacal organ music seeps from the back of the monitor as I 
laugh some more.)


-- 
 Bill Murphy                          murphy@newton.physics.purdue.edu
Enjoying my Amiga 2000, but holding out for a real computer: The Amiga 3000!!