Xref: utzoo comp.sys.ibm.pc.rt:1308 comp.sys.ibm.pc:42571
Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!bunda
From: bunda@cs.utexas.edu (John Bunda)
Newsgroups: comp.sys.ibm.pc.rt,comp.sys.ibm.pc
Subject: Re: WD1005 as 2nd controller in PC/RT
Summary: check the cabling
Message-ID: <109@darkstar.cs.utexas.edu>
Date: 22 Jan 90 23:21:03 GMT
References: <91@blender.UUCP>
Followup-To: comp.sys.ibm.pc.rt
Organization: U. Texas CS Dept., Austin, Texas
Lines: 20

In article <91@blender.UUCP>, herb@blender.UUCP (Herb Peyerl) writes:

> My question therefore is:  Does anyone know how to make a WD1005-ARM
> controller act as a second controller?  

Assuming your MFM controller is compatable with the ST506, this should work
(I have two RTs set up this way).  The jumper settings shown in the
Setup Guide are correct, but the cabling is shown wrong (at least in my
setup book).  The connectors on the second controller need to be on
J2 and J3 of the wd1005a-arm, not J2 and J4 as shown in the book.

-John



-- 
......................................................
John Bunda                         METRIC Project
Voice: (512) 471-9710              UT Austin CS Dept.      
Internet: bunda@cs.utexas.edu      Austin, Texas 78712