Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!van-bc!ubc-cs!alberta!calgary!xenlink!terry
From: terry@xenlink.uucp (Terry Cioni)
Newsgroups: comp.sys.mac
Subject: BlackBox
Message-ID: <1990Jan18.125910.1793@xenlink.uucp>
Date: 18 Jan 90 12:59:10 GMT
Organization: Xenlink - a part of TVC Systems
Lines: 17

After a rather busy several months - I had sometime to play around with a few
of the binaries that have come across the net recently.  I am always taken
with the effort that goes into the pd/shareware software that shows up.  If
only I had the same talent.....

One I was looking forward to using - has given me a problem, which has most
likely been dealt with on the net already - but I would appreciate any sug-
gestions.

I installed Blackbox - on an SE/30 (4megs of RAM) with a Laserwriter NT.  The
problem is that with Blackbox installed I can not print.  I removed all other
cdevs, etc to ensure no conflicts existed, but it did not solve the problem.
Any suggestions - works around, or whatever would be greatly appreciated.  I
really would like to use BlackBox.

terry@xenlink - 
UUCP is alberta!calgary!xenlink!terry