Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!uwm.edu!zaphod.mps.ohio-state.edu!van-bc!
From: lphillips@lpami.wimsey.bc.ca (Larry Phillips)
Newsgroups: comp.sys.amiga.hardware
Subject: Re: A2286 woes
Message-ID: <1276@lpami.wimsey.bc.ca>
Date: 18 Mar 90 13:09:24 GMT
Lines: 22
Return-Path: <lpami!lphillips>
To: van-bc!rnews

In <90077.201706CJC105@psuvm.psu.edu>, CJC105@psuvm.psu.edu (Chris) writes:
>I'm having problems with the A2286.  When the A2000 cover is on, the A2286
>doesn't work (ie Janus library not found).  When it's off, it works.  If I
>pull the cover forward an inch or so the 2286 will work, but any less than
>that and it doesn't.  I've ruled out the possibility of a short or pressure
>caused by the cover.   Could it be RF interference?  Any ideas?

The most prevalent cause for Janus library not found is poor seating of the
Bridge board. Sounds like your cover is putting pressure on the rear section of
the case, and in turn causing the Bridge to pull to the rear. Try it without
the screw holding the Brige backplate to the case. If it works, you've found
the problem.

-larry

--
Entomology bugs me.
+-----------------------------------------------------------------------+ 
|   //   Larry Phillips                                                 |
| \X/    lphillips@lpami.wimsey.bc.ca -or- uunet!van-bc!lpami!lphillips |
|        COMPUSERVE: 76703,4322  -or-  76703.4322@compuserve.com        |
+-----------------------------------------------------------------------+