Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!yale!mintaka!ogicse!ucsd!hub!6600pete
From: 6600pete@ucsbuxa.ucsb.edu (GurgleKat [Pete Gontier])
Newsgroups: comp.sys.mac.programmer
Subject: Re: Can't   RUN  my LS Pascal programs on my new II ci
Message-ID: <4344@hub.UUCP>
Date: 16 Mar 90 20:32:13 GMT
References: <564@sierra.stanford.edu>
Sender: news@hub.UUCP
Reply-To: 6600pete@ucsbuxa.ucsb.edu
Lines: 20

There are two pages after this article without a reply to it on them,
so I guess I will go out on a limb and assume our friend Mr. Siegel
is vacationing in the Bahamas (that's wishing you well, Rich! Probably
you're working too hard to read the net for a while...)

From article <564@sierra.stanford.edu>, by talwar@sierra.Stanford.EDU (Somit Talwar):
> I recently upgraded my computer from a MAC II CX  to a MAC II CI.
> Now, I find that I cannot run any of the programs I had written in
> LightSpeed Pascal.  I get a System Error ID = 01 whenever I try to run
> any of my programs.  This is true for even the simplest of them. I can
> however build and save my projects, which subsequently run from the
> finder. I am utterly confused.

The current version of THINK Pascal is 2.03. 2.03 is an update for the
IIci and the Portable. There's an updater kit available via anonymous
ftp at sumex-aim.stanford.edu. Good luck.
--
             Pete Gontier, Kiwi Software; Kiwi's opinions not presented here
                          Editor, Macker, the Online Mac Programming Journal
InterNet 6600pete@ucsbuxa.ucsb.edu; BitNet 6600pete@ucsbuxa; AppleLink D0862