Path: utzoo!attcan!uunet!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!AEARN.BITNET!K312240
From: K312240@AEARN.BITNET (Klaus Kusche)
Newsgroups: comp.sys.transputer
Subject: Inmos/3L par C, flood fill: Help needed!
Message-ID: <9003261342.AA14881@tcgould.TN.CORNELL.EDU>
Date: 26 Mar 90 19:41:52 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 26


Dear Mailing List:

A question concerning the Inmos/3L Parallel C flood fill configurer:
* Must the link the whole network boots from (i.e. the link connecting
  the root transputer to the host) always be link 0 of the root
  transputer, or will the same (binary) code also work correctly on
  networks where the host is connected to link 1, 2 or 3 of the root
  transputer?
* If the code depends on the boot link, is there any way to change the
  default from link 0 to something else?

Any help appreciated!

************************************************************************
* Klaus Kusche                                                         *
* Research Institute for Symbolic Computation                          *
* Johannes Kepler University           Tel: +43 7236 3231 67           *
* A-4040 Linz                          Telex: (Austria) 22323 uni li a *
* Austria (Europe)                     Fax: +43 7236 3231 30           *
*                                                                      *
* Bitnet:           K312240@AEARN                                      *
* Arpa/CS/Internet: K312240%AEARN.BITNET@CUNYVM.CUNY.EDU               *
* UUCP:             mcvax!aearn.bitnet!K312240                         *
* Janet:            k312240@earn.aearn or k312240%aearn@earn-relay     *
************************************************************************