Path: utzoo!attcan!uunet!wuarchive!zaphod.mps.ohio-state.edu!think!mintaka!bloom-beacon!bu.edu!xylogics!transfer!lectroid!jjmhome!cpoint!jeff
From: jeff@cpoint.UUCP (Jeffrey J. Griglack)
Newsgroups: comp.sys.amiga
Subject: Re: wordprocessors on ami
Message-ID: <4594@cpoint.UUCP>
Date: 10 Apr 90 13:06:24 GMT
References: <4Apr1990145828134@BLEKUL11.BITNET> <14842@s.ms.uky.edu> <400@icebox.nsc.com> <13310@thorin.cs.unc.edu> <401@icebox.nsc.com>
Reply-To: jeff@cpoint.UUCP (Jeffrey J. Griglack)
Organization: Clearpoint Research Corp., Hopkinton Mass.
Lines: 22

In article <401@icebox.nsc.com> waggoner@dtg.nsc.com (Mark Waggoner) writes:
>Apparently, Prowrite 3.0 (which is not yet available, as far as I can
>tell) has multicolumn support.  Previous versions did not.
>


I talked with New Horizons Software yesterday.  They said that the update
notification cards where going out in the mail now, so I should get mine
next week.  If this is so, ProWrite 3.0 is available.

Also, I have been very pleased with ProWrite's output on my 9 pin dot
matrix printer.  If I set the number of dpi higher (through the "print
options" menu selection, or something like that) I got very good output.
It took a while, but I am willing to wait.



-- 
=============================================================================
Now I quess I'll have to tell 'em, that I've got no cerebellum - The Ramones
	Jeff Griglack {decvax, cybbax0, mirror}!frog!cpoint!jeff
=============================================================================