Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!wuarchive!zaphod.mps.ohio-state.edu!samsung!cs.utexas.edu!uunet!willett!ForthNet
From: ForthNet@willett.UUCP (ForthNet articles from GEnie)
Newsgroups: comp.lang.forth
Subject: Forth Engines / Harris
Message-ID: <906.UUL1.3#5129@willett.UUCP>
Date: 6 May 90 03:55:30 GMT
Organization: Latest link in the ForthNet chain.  (Pgh, PA)
Lines: 14


 Date: 05-04-90 (17:10)              Number: 485 (Echo)
   To: JOE BROWN                     Refer#: 462
 From: ANIL RODRIX                     Read: NO
 Subj: HARRIS RTX DESIGN CONTEST     Status: PUBLIC MESSAGE

 I havent even booted up yet; but reading thru the lit it seems memory
 will almost surely be needed. I'd like to run at 2 MHz but dont have a
 replacement ( 4MHz osc.). Since my proposal was a machine to cut and 
 weld pipe intersections I cant figure out exactly what I could send as
 an entry; the entry is supposed to fit on the RTXEB. 
-----
This message came from GEnie via willett through a semi-automated process.
Report problems to: 'uunet!willett!dwp' or 'willett!dwp@gateway.sei.cmu.edu'