Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!umich!yale!cmcl2!lanl!opus!dante!mmartin
From: mmartin@nmsu.edu (Marilyn Martin )
Newsgroups: comp.sys.amiga
Subject: Putting RAM on the 2091
Keywords: RAM
Message-ID: <618@opus.NMSU.EDU>
Date: 9 May 90 15:03:46 GMT
Sender: news@nmsu.edu
Distribution: usa
Lines: 16


 I just got RAM put on my 2091.  Used Mergemem to assign addresses.
 Memory shows up on Workbench and on status line in Sculpt 4D.  Here's
 the problem: when Sculpt tries to use RAM above standard 3M, it gurus!
 Has anybody out there installed RAM on their 2091?  I have a 2500/30;
 is the coprocessor causing a problem?  Also: when I used RAMtest it
 tells me the RAM is there but gives me BAD BIT reports on all addresses.
 Help!
 Signed, Megafrustration

 I can't believe I maxed my card for this!!!! 
 
 Marilyn Martin
 New Mexico State University
 Computer Center    
 Las Cruces NM 88003