Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!uwm.edu!cs.utexas.edu!uunet!mcsun!hp4nl!telmail!neabbs!alexhagn From: alexhagn@neabbs.UUCP (ALEXANDER HAGEN) Newsgroups: comp.sys.amiga Subject: 14 Mhz on A2000??? Message-ID: <378152@neabbs.UUCP> Date: 9 May 90 22:57:33 GMT Organization: NEABBS multi-line BBS +31-20-717666 (13x), Amsterdam, Holland Lines: 39 Recently, I have downloaded a file, describing how to increase the speed of the A500 to 14 MHZ. In the accompaning manual Leslie Ayling tells that the performance of the Amiga is increased with 70%! Well, that's for the A500. However, I own a A2000. This is my hardware configurartion: A2000B (Rev 4.4) 2 MB Microbotics DIP Fast RAM Kickstart 1.3 Agnus 8372 (1MB Chip RAM) XT Board Seagate PC Harddisk ST-138R (30MB, RLL) PC Parrallel/Serial interface card. According to the manual the same electronic circuit can be used for the A1000 and A2000. So, I will probably build it. However, I intend to use the processor slot to hold the upgrade board (and remove the old 68000 from it's socket). The advantages are clear: * No bending of CPU pins * No soldering to the Agnus socket * No soldering to the Denise socket Because I don't see a way to keep the wires to the switch SHORT in a A2000, I probably will leave the 7/14 Mhz switch out. Before I start, I would like to hear about your experiences with the 14 Mhz extension; especially if you have altered your A2000! Also, I wonder wether there are any timing or clock problems? I don't expect this, since only the CPU will work faster. Finally, can anyone tell me wether I can put a expansion card into the CPU slot, connecting only the pins required by the CPU and the 14 Mhz extension? ------------------------------------------------------------------------- _ Alexander Hagen | PRIV. MSG. IN DUTCH, GERMAN OR ENGLISH! _/_\__ Newtonstraat 20 | BBS (+31) 20-5733533 ````-o--o- 4532 KH Terneuzen | UUCP alexhagn@neabbs.UUCP The Netherlands | Fido 2:280/2 -------------------------------------------------------------------------