Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!ucsd!ucbvax!MTUS5.BITNET!TDSTRONG
From: TDSTRONG@MTUS5.BITNET (Tim Strong)
Newsgroups: comp.sys.handhelds
Subject: HP48SX -> Apple IIc connection
Message-ID: <9005091425.AA26708@hercules.csl.sri.com>
Date: 9 May 90 15:08:56 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Distribution: inet
Organization: The Internet
Lines: 18


     Has anyone out there connected their 48 to an Apple II yet.
 I doubt HP has plans to make a cable for it (not a office computer).
 Any how if someone has managed to make a cable for an Apple II I'd like
 to see how its hooked up, especially if its one made for a IIc.  I'm
 also curious because I'm not sure if the serial port on a IIc gives
 RS232 compatible signals.

 A tiny little complaint as well. Why use a male connector in the calculator?
 The female connector is much more sturdy (no pins to break off).  I'd much
 rather buy a new cable then have to send in my calculator if a pin got bent.

===========================================================================
     ___                     Tim Strong  <TDSTRONG@MTUS5.BITNET>
     |__)  _   _|  _   _     Michigan Technological University
     |   (_| (_| (_| |      Houghton, MI  49931
                                        U.S.A.
===========================================================================