Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!uwm.edu!zaphod.mps.ohio-state.edu!samsung!emory!kd4nc!cld
From: cld@kd4nc.UUCP (Charles D'Englere)
Newsgroups: comp.sys.nsc.32k
Subject: Re: Drive Enclosure..
Message-ID: <4463@kd4nc.UUCP>
Date: 9 May 90 17:53:07 GMT
References: <9005082009.AA00239@manatee.UUCP>
Organization: KD4NC HAM Packet Radio Gateway
Lines: 36

news@daver.bungi.com writes:


>I thought I would share with the group how I packaged the 9380S drives
>which I purchased in the group buy a while back.  

[*** rest deleted ***]

>One modification I am thinking about is adding the ability to select
>SCSI ID's from a switch on the rear surface.  This reminds me,
>does anyone know of a simple way in which the SCSI terminator
>resistors could be 'inserted/removed' via a rear surface 
>switch ??

>Best regards,
>johnc
>-- 

One way is to use the same terminators that Apple uses on its SCSI drives.
It fits on the end of the last SCSI device.

 ----------       ------------       ------------       -----------    ------
| UNIX Box |-----| SCSI DRIVE |-----| SCSI DRIVE |-----| SCSI TAPE |--| TERM |
 ----------       ------------       ------------       -----------    ------

I have made a little switch unit, that can be adaptive to any SCSI drive to
allow changing the address just buy pushing a button. This makes setting the
SCSI address very easy.

Good luck,
Charles

-- 
C. D'Englere Consulting          UUCP: {...!gatech,!emory}!kd4nc!cld
  Charles L. D'Englere             Phone: 404+3259074
    1409 Bronze Leaf Ct.             Stone Mountain, GA 30083