Xref: utzoo comp.sys.amiga:58884 comp.sys.amiga.tech:12381
Path: utzoo!attcan!uunet!ogicse!dali!uakari.primate.wisc.edu!zaphod.mps.ohio-state.edu!rpi!bu.edu!mirror!rayssd!anomaly!cole
From: cole@anomaly.sbs.com (Cole Calistra)
Newsgroups: comp.sys.amiga,comp.sys.amiga.tech
Subject: 2090 Problems with GVP Controller!!!!
Keywords: 2090,need help,GVP,2090 and GVP
Message-ID: <1693@anomaly.UUCP>
Date: 31 May 90 23:36:55 GMT
Sender: cole@anomaly.UUCP
Organization: Anomaly - Rhode Island's Open Access *NIX - 1 (401) 455-0347 PEP
Lines: 28

Hello, 
	I have an annoying problem with a 2090 controller I recently purchased.
I also have a GVP Impact Hard Card (46M) with two partitions.  My problem
lies in the fact that the GVP is autobooting and I want it to boot it's 
two partitions and then start the 2090 (which isn't autobooting).  The
problem is that I cannot A) Get the 2090 to recognize any sort of a mountlist
and B) Get the 2090 to recognize a drive as the DH2:.  I have a MiniScribe
8024 (20 meg ST-506 drive, I'm not sure of the number).  
 
	If I disable the autoboot on the GVP and just use the 2090, I can do that
fine.  It lowleveled, and highlevel formatted fine!  But I cannot seem to get
it to recognize the drive as being DH2:.  If I do a binddrivers, it loads
the drive as DH0: or DH1: (depending on how the drive select jumper on the
drive is set {yes, I tried putting it on 3 instead of 1 or 2}) and overrides
the existing DH0:  or DH1:  partition on the GVP.  If I mount the drive as
DH2:  (using a mountlist derived from the ones on the 2090 disk) it either
locks or gives me a software failure if I try to load the driver (by
accessing the disk).  Any help is VERY GREATLY appreciated!!  Please send
me mountlists, and/or sample configurations, etc..
 
            >>If you post a reply, please mail it to me, also<<<
 
 =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
 |                            Cole C. Calistra                             |
 |                     UUCP:  uunet!rayssd!anomaly!cole                    |
 |                      INTERNET: cole@anomaly.sbs.com                     |
 |     Four Fingers and a Thumb Software - The Art of Amiga Development    |
 =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=