Xref: utzoo comp.sys.att:9702 comp.sys.ibm.pc.programmer:1759
Path: utzoo!attcan!uunet!seismo!ukma!rex!uflorida!haven!decuac!decwrl!elroy.jpl.nasa.gov!sdd.hp.com!zaphod.mps.ohio-state.edu!uwm.edu!ux1.cso.uiuc.edu!iuvax!mailrus!accuvax.nwu.edu!delta.eecs.nwu.edu!kaufman
From: kaufman@delta.eecs.nwu.edu (Michael L. Kaufman)
Newsgroups: comp.sys.att,comp.sys.ibm.pc.programmer
Subject: Re: How does DOS time work?
Message-ID: <8546@accuvax.nwu.edu>
Date: 2 Jun 90 08:28:39 GMT
References: <1094.266605B1@onebdos.UUCP> <980@soleil.UUCP>
Sender: news@accuvax.nwu.edu
Reply-To: kaufman@delta.eecs.nwu.edu (Michael L. Kaufman)
Organization: Northwestern U, Evanston IL, USA
Lines: 15

In article <980@soleil.UUCP> gopstein@soleil.UUCP (Rich Gopstein) writes:
>
>The question is:  How can I get generic DOS (4.0 in my case), to keep
>the correct time given the 18.75Hz clock rate?
>
>Rich Gopstein
>
>gopstein@soleil.nj.semi.harris.com
>..!rutgers!soleil!gopstein

The easiest way to do this is to write a little tsr that sets the clock ahead
a few seconds every minute.  I did not work out just how many seconds you 
will need to set it ahead, but it is easy to figure it out.

Michael Kaufman