Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!samsung!zaphod.mps.ohio-state.edu!sdd.hp.com!hp-pcd!hpfcso!hpfcdc!richard
From: richard@hpfcdc.HP.COM (Richard Artz)
Newsgroups: comp.sys.hp
Subject: Re: LaserJet II raster help
Message-ID: <5570420@hpfcdc.HP.COM>
Date: 31 May 90 06:11:25 GMT
References: <1418@marlin.NOSC.MIL>
Organization: HP Ft. Collins, Co.
Lines: 24

RE: / atkins@marlin.NOSC.MIL (Hugh T. Atkins) /  4:04 pm  May 29, 1990 /

Hugh,
	You didn't say what,if anything, you get from the printer.
The printer should be in raw-mode (lp -oraw).
You are right that there must not be any CR/LF in the data stream.
The escape-sequence for each row includes the number of bytes in
that row.
I'd put a form-feed at the end, before the second reset.

I've played with the rasters, we have scanned images of our users
that print on the banner-pages :-) I don't see anything else wrong
with your example -- but then I'm at home and can't check the manual.

You might write the data to a file and then dump the data to check
the content.

Maybe someone else will see something I missed.
 
 Richard Artz / GSY Learning Products / 303-229-2036 / richard@hpfcww.fc.hp.com
 Hewlett-Packard / MS11 / 3404 E. Harmony Road / Fort Collins, CO 80525-9599 
This response does not represent the official position of, or statement by, the
Hewlett-Packard Company.  The above data is provided for informational purposes
only. It is supplied without warranty of any kind.