Path: utzoo!utgpu!news-server.csri.toronto.edu!clyde.concordia.ca!uunet!aplcen!uakari.primate.wisc.edu!zaphod.mps.ohio-state.edu!mips!prls!pyramid!ctnews!mitisft!dold
From: dold@mitisft.Convergent.COM (Clarence Dold)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Drive problem
Message-ID: <1486@mitisft.Convergent.COM>
Date: 27 May 90 22:31:02 GMT
References: <112@victoria.cs.utexas.edu>
Organization: Convergent Technologies, San Jose, CA
Lines: 13

in article <112@victoria.cs.utexas.edu>, glenn@cs.utexas.edu (Gwangwu Lai) says:

> it out, managed to get it to work, and put it back in the 3.5" drive bay.  It
> worked, and then it failed when I put the four screws back.  As I couldn't

I recall the vendor manual from some disk/tape device (I can't remember which)
advising that only three of the four mounting screws be used, if mounting from
the bottom.  If you used the side rails, you could use all four screws.
-- 
---
Clarence A Dold - dold@tsmiti.Convergent.COM            (408) 435-5293
               ...pyramid!ctnews!tsmiti!dold        FAX (408) 435-3105
               P.O.Box 6685, San Jose, CA 95150-6685         MS#10-007