Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!uwm.edu!csd4.csd.uwm.edu!aragorn
From: aragorn@csd4.csd.uwm.edu (Steve J White)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Hard drive help
Message-ID: <4183@uwm.edu>
Date: 28 May 90 16:34:07 GMT
References: <9005271641.AA17287@alf.unomaha.edu>
Sender: news@uwm.edu
Reply-To: aragorn@csd4.csd.uwm.edu (Steve J White)
Organization: University of Wisconsin-Milwaukee
Lines: 18


On the back of the Seagate there is a bank of jumper pins.  If the drive I/F
cable has a twist in it BOTH drives should be set for drive select 2, or 1 if
your drive has a 0 setting.  Set the Seagate to the second jumper in from the 
left when looking at the back of the drive with the controler card down.  This
sets the drive as select 2.  Again, both drives should be set this way IFF 
is a twist in the cable (the wider one).  If there is no twist then the boot
drive should be select 1 and the second as 2, or 0 and 1 respectively depending
on the drives markings.

- Steve


--
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
[]  Steve J. White		 |  "A spirit with a vision is a dream     []
[]  aragorn@csd4.csd.uwm.edu     |       with a mission."    - Rush        []
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []