Newsgroups: comp.unix.questions Path: utzoo!utgpu!watserv1!watmath!focsys!larry From: larry@focsys.uucp (Larry Williamson) Subject: Re: Forms maker for Unix In-Reply-To: ntm1477@dsacg3.dsac.dla.mil's message of 23 May 90 17:06:52 GMT Message-ID: Sender: larry@focsys.uucp (Larry Williamson) Organization: Focus Automation Systems Inc. Waterloo, Ontario. References: <2200@dsacg3.dsac.dla.mil> Date: 25 May 90 12:52:01 Lines: 23 In article <2200@dsacg3.dsac.dla.mil> Jared McNeal writes: I'm looking for a program that can be used to design forms on the Unix system. The program should be able to do math and other calculations. I't should allow you to design any type of form and print the form(sideways if possible) with no problems. We've been looking for just such a beast. We've found a few that may be appropriate for your needs. "Vermont Views" from Vermont Creative Software, (802) 848-7731 "JAM" from Jyacc, New York (212) 267-7722 "Cscape" from Oakland Group, Cambridge, MA. (617) 491-7311 The first two advertize in Unix world or Unix Review. There was a review in April's Unix Review of these two packages. All three have nifty dos demos that show what they can do. They all have versions for dos, unix, xenix, and others. We wanted one that had a QNX version. Only Cscape seems to have this. Check them out, they all look good. They are all reasonably priced. -Larry