Path: utzoo!utgpu!news-server.csri.toronto.edu!clyde.concordia.ca!uunet!tut.cis.ohio-state.edu!giza.cis.ohio-state.edu!erd From: erd@giza.cis.ohio-state.edu (Ethan R Dicks) Newsgroups: comp.sys.amiga Subject: Help needed with dNET 2.x (1.10 works fine) Keywords: direct-connect dNET Message-ID: <81141@tut.cis.ohio-state.edu> Date: 4 Jun 90 04:22:59 GMT Sender: news@tut.cis.ohio-state.edu Reply-To: Ethan R Dicks Distribution: na Organization: Ohio State University Computer and Information Science Lines: 21 This has probably been discussed before, but I must have missed it... I have a setup with two Amigas (A500 and A1000) adjacent, with their serial ports connected. I can get dNET 1.10 (from Fish 145), but I cannot get dNET 2.10 working. When I "run dnet" on both machines, I get the initial windows, but when I try to start dNET, the one window goes away, but the other window just prints some garbage. dNET 1.10 works just fine. How do you hook two Amigas back-to-back with dNET 2.x and a direct connect cable? I can't seem to find any relevant switches in the file dnet.doc. Thanks, -ethan -- Ethan R. Dicks | ###### This signifies that the poster is a member in Software Results Corp| ## good sitting of Inertia House: Bodies at rest. 940 Freeway Drive N. | ## Columbus OH 43229 | ###### "You get it, you're closer."