Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!intercon!news
From: amanda@mermaid.intercon.com (Amanda Walker)
Newsgroups: comp.sys.mac.comm
Subject: Re: SLIP/Telnet config?
Message-ID: <266D4D2A.507F@intercon.com>
Date: 6 Jun 90 18:36:25 GMT
References: <1990Jun6.141624.16046@uwasa.fi>
Sender: usenet@intercon.com (USENET The Magnificent)
Reply-To: amanda@mermaid.intercon.com (Amanda Walker)
Organization: InterCon Systems Corporation, Herndon, VA
Lines: 13

In article <1990Jun6.141624.16046@uwasa.fi>, hv@uwasa.fi (Harri Valkama LAKE)
writes:
> If I take an ordinary
> config.tel from NCSA Telnet package what I should change
> for SLIP/Telnet. There was no documentation included.

As I remember, try "hardware=slip9600" (replace 9600 with the baud rate you
want).

--
Amanda Walker, InterCon Systems Corporation
--
"If we don't succeed, then we run the risk of failure."  -- Dan Quayle