Path: utzoo!attcan!uunet!cs.utexas.edu!tut.cis.ohio-state.edu!att!cbnews!military From: PAPAI@kcgl1.eng.ohio-state.edu (Jonathan Papai) Newsgroups: sci.military Subject: Re: RE: swords Message-ID: <1990Jun4.184518.28293@cbnews.att.com> Date: 4 Jun 90 18:45:18 GMT References: <16089@cbnews.ATT.COM> Sender: military@cbnews.att.com (William B. Thacker) Distribution: na Organization: Ohio State University Lines: 44 Approved: military@att.att.com From: PAPAI@kcgl1.eng.ohio-state.edu (Jonathan Papai) x x xFrom: "Jonathan L Wilson" x xmathers@titan.trl.oz.au (Steven Mathers) write x> Assuming , for whataver reason, that the military found some real use x> for swords on a modern battlefield, what would they make them out of x> these days. Say military R&D went all out to get the best sword they x> could come up with in hardness, sharpness, etc... x xA few years ago I had an undergraduate class in materials science that tackled xthis issue out of curiousity. The conclusion (I remember faintly) was that a x"maraging" steel, a steel with very high proportions of alloying elements, was xjust the ticket. It contained, I think, some 20-30% titanium. Maraging steels xcombine hardness with extreme toughness. All this is quite foggy now, perhaps xsomeone in the business knows more. The "active ingredient" in maraging steels is typically 18 % nickel. However I believe that the composite solutions suggested are probably still better. If we restrict to monolithic materials the moderator's suggestion of a D2 tool steel is probably more abrasion resistant, with adequate toughness, while the similar D7 is probably even better. In "Heat Treater Guide", American Soc. Metals,1982, it says that D7 is among the most abrasion resistant steels known. A nitriding treated 4340 is aweful case hard also. x xJonathan L Wilson | "I am TEFLON, you are cyanoacrylate. xTRW Systems Integration Group | Slides off me and sticks to you." xMILNET: WILSONJL@HQHSD.BROOKS.AF.MIL | xPhone: (512) 536 2236 | xStandard disclaimer applies. | **************************************************************** Jon Papai * I think of this project as Mater.Sci.&Eng * quite important, it is you Ohio State Univ. * I take lightly. Papai@kcgl1.eng.ohio-state.edu * -James T. Kirk ****************************************************************