Path: utzoo!attcan!uunet!snorkelwacker!bloom-beacon!eru!luth!sunic!sics.se!bula!bjornk
From: bjornk@bula.se (Bjorn Knutsson)
Newsgroups: comp.sys.amiga.tech
Subject: Re: Lattice 5.05 with WShell...
Message-ID: <7917@bula.se>
Date: 9 Jun 90 14:09:01 GMT
References: <267063fd-6b6comp.sys.amiga.tech@tronsbox.UUCP>
Sender: rnews@bula.se
Reply-To: Bjorn Knutsson <bjornk@bula.se>
Distribution: comp
Organization: Bjorn's Amiga, Sweden
Lines: 27

In article <267063fd-6b6comp.sys.amiga.tech@tronsbox.UUCP> bleys@tronsbox.UUCP (Bill Cavanaugh) writes:
>I attempted to use the Lattice "lc" command to compile a file that was in
>RAM:.  I typed "lc -Lm file.c", and got the message "File RAM:-Lm.c does not
>exist.  Try again."
>
>What's the deal?  It works with a standard CLI, but not with WShell/ConMan. 
>Is there some path expanding going on?  Is there some way I can turn it off?

I belive this is caused by a bug in Lattice startup code. It doesn't
like filenames/paths with spaces. You can solve the problems this causes
by a) Renaming RAM: to "RAM_DISK" or b) Removing the "pathname" option
in your Config-WShell.

>/********************************************************************
> *      All of the above copyright by the below.                    *
> *                                                                  *
> * Bill Cavanaugh       uunet!tronsbox!bleys                        *
> *                                                                  *
> *  "You can only be young once, but you can be immature forever."  *
> *              Larry Anderson                                      *
> ********************************************************************/

---
Bjorn Knutsson        / USENET: bjornk@bula.se or sunic!sics!bula!bjornk
Stangholmsbacken 44  /  Phone : +46-8-710 7223
S-127 40 SKARHOLMEN /     "Oh dear, I think you'll find reality's on the
S W E D E N        /       blink again."  -- Marvin The Paranoid Android