Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!uunet!overload!dillon From: dillon@overload.UUCP (Matthew Dillon) Newsgroups: comp.sys.amiga.tech Subject: Re: How do you reply to !foo.uucp addresses? Message-ID: Date: 10 Jun 90 23:55:13 GMT References: <1990Jun4.152017.8229@csmil.umich.edu> <2189@tmiuv0.uucp> Lines: 39 >In article <2189@tmiuv0.uucp> rick@tmiuv0.uucp writes: > >As a further example, to send mail from my home Amiga to this system, the >whole bang path is: > > (host system is amoeba2, my user name is "rps2"): > conexch!ccicpg!perigrine!uunet!zardoz!tmiuv0!rick > >A bit messy. That's why "smart mailers" and "domains" are so nice. Look >| V | uunet!zardoz!tmiuv0!rick (<-- Work (ugh!)) | >|--------+ uunet!zardoz!xyclone!sysop (<-- Home Unix (better!)) | >| uunet!perigrine!ccicpg!conexch!amoeba2!rps2 (<-- Home Amiga (Best!!) | The proper way to give a bang path to your site is to ALWAYS begin with a FULLY DOMAINED host name. For example (using the example above): uunet.uu.net!perigrine!ccicpg!conexch!amoeba2!rps2 In most cases the paths are not even that long... if, for example, you knew the full domain name for 'conexch' (assuming it has one), you could simply say conexch.!amoeba2!rps2 Just saying 'uunet' is not good enough in many cases. Some machines run only the domain stuff (you have to say 'uunet.uu.net!overload!dillon' to get to me, others run the whole database (where you can just say 'overload!dillon' to get to me), and still others do not run any database at all, in which case you must know the path to the nearest site which does have the database. Some machines are on the INTERNET, others a simple UUCP connection, some on BITNET, etc... using fully domained host names is the way that will most likely get the mail to its destination. -Matt -- Matthew Dillon uunet.uu.net!overload!dillon 891 Regal Rd. Berkeley, Ca. 94708 USA