Path: utzoo!attcan!uunet!samsung!dali.cs.montana.edu!rpi!uupsi!sunic!luth!d88-mbe From: d88-mbe@sm.luth.se (Michael Bergman) Newsgroups: comp.sys.amiga.tech Subject: Ansi control sequences in CON: & NEWCON: Message-ID: <1005@tau.sm.luth.se> Date: 13 Jun 90 11:48:46 GMT Reply-To: Michael Bergman Organization: University of Lulea, Sweden Lines: 39 UUCP-Path: {uunet,mcvax}!sunic!sm.luth.se!d88-mbe Hello, everyone. The AmigaANSI terminal control sequences continue to give me trouble. I have been looking for them in all the docs I have (except the RKM:s because I don't have then with me right now :-( but I found nothing that described them all like I want them. Sure, I know that *E[1m changes attributes, *E[xx;yyH is absolute cursor positioning and so on. But what I'd like is a complete table of *all* the control sequences available in CON:, NEWCON:, CONMAN: and RAW:. (decimal ASCII values for everything too!) Something like this: Cursor positioning ESC+[xx;yyH Bold on ESC+[1m Cursor up ESC+[nA Cursor down ESC+[nD Delete line ESC+[nM Form feed ^L Line feed ^J Carriage return ^M (Where n stands for a dec. number in ASCII form) Has someone produced such a table or know how I can get all the info?? Note that I want *all* of it - CON:, NEWCON:, CONMAN: and RAW:. I've also tried using Kent Polks (kent@swrinde.nde.swri.edu) Amiga termcap 1.2 with Fterms in DNet 2.10, but it doesn't work at all. Anyone else had any luck? I'm planning to find out what's wrong and write a termcap that works with DNet 2.10 run under UNIX. Mike -- Michael Bergman Internet: d88-mbe@sm.luth.se // Undergrad. Comp. Eng. BITNET: d88-mbe%sm.luth.se@kth.se \X/ U of Lulea, SWEDEN ARPA: d88-mbe%sm.luth.se@ucbvax.berkeley.edu UUCP: {uunet,mcvax}!sunic.se!sm.luth.se!d88-mbe