Path: utzoo!attcan!uunet!tut.cis.ohio-state.edu!pacific.mps.ohio-state.edu!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!uflorida!haven!udel!sbcs!nyit!aca
From: aca@nyit.UUCP (Al Arthur)
Newsgroups: comp.sys.amiga.tech
Subject: Re: Diskperf with A3000
Keywords: Strange behavior of Diskperf
Message-ID: <404@nyit.UUCP>
Date: 14 Jun 90 18:21:56 GMT
References: <1512@ramz.UUCP> <12526@cbmvax.commodore.com>
Organization: NYIT Computer Graphics Laboratory
Lines: 20

In article <12526@cbmvax.commodore.com> jesup@cbmvax (Randell Jesup) writes:
>	Check to make sure the mask for the partition is 0xfffffffc.  If it's
>0xfffffe, then it's set up wrong.

I never did figure-out what the mask was really used for,  nor what it
should be set to on my machine.  Can you explain it to me? (Thanks)

I have a 2090A, and early docs on it that don't seem to contain complete
information about the Mountlist entries.

My machine has a 2630, 2090A, 1)2052, 2) SCSI Disks, 1)TapeDrive


	Thanks, Al

-- 
Alex Arthur, System Programmer/UUCP Administrator
New York Institute of Technology - Computer Graphics Laboratory
Gerry House, Old Westbury, New York 11568
Phone:(516) 686-7644	UUCP: ...!{sbcs.sunysb.edu,philabs}!nyit!aca