Path: utzoo!attcan!uunet!van-bc!ubc-cs!alberta!ncc!isa!darius
From: darius@isa.uucp (Darius S. Naqvi)
Newsgroups: comp.sys.atari.st
Subject: Re: TeX 3.0 for ST??
Message-ID: <1990Jun10.152941.11742@isa.uucp>
Date: 10 Jun 90 15:29:41 GMT
References: <1990Jun6.051803.16242@tukki.jyu.fi>
Reply-To: darius@isagate.nexus.ca (Darius S. Naqvi)
Organization: ISA Corporation
Lines: 22

In article <1990Jun6.051803.16242@tukki.jyu.fi> suhonen@tukki.jyu.fi (Timo Suhonen) writes:
>
> Has the TeX 3.0 stuff been ported to ST yet??  And does it run
> ina 1 Meg ST?? I tried the un*x C -source, but all it says is
> 'not enough memory', and the text comes from Gul\"am, not from
> virTeX. 
>
>-- 
>Timo Suhonen                                           suhonen@tukki.jyu.fi
>                  I am logged in, therefore I am

Did you run out of memory when you compiled it, or when you tried to
run it? If it was a run-time error, then you might only need to change
a #DEFINE, or else re-boot without DA's. When I run CommonTeX 2.9, I
boot with only the control panel and fldr100.prg, and it runs fine. If
I have other autoboots or desk accessories, I get the 'not enough
memory' message.
-- 
Darius S. Naqvi                    uucp: darius%isagate@uunet.uu.net
ISA Corp.                                darius@isagate.isac.UUCP
Edmonton, Alberta, Canada                {uunet,alberta}!ncc!isagate!darius
(403) 420-8081 or (403) 441-4121   Home: (403) 439-1444