Path: utzoo!attcan!uunet!wuarchive!swbatl!texbell!uudell!bigtex!texsun!digi.lonestar.org!ajahnv!alfredo From: alfredo@ajahnv.lonestar.org (Alfredo Jahn V) Newsgroups: comp.sys.amiga.tech Subject: EXECUTE errors Message-ID: Date: 1 Jul 90 14:30:01 GMT Lines: 19 I have never used the "execute" command before and I'm having some problmes... I am trying a new boot process where a short startup- sequence file EXECUTEs another file on the hard disk. I get the following error: EXECUTE: No K directive DH0:c/execute failed returncode 20 The file I am executing does not take any parameters. Do I still need to add a .K at the start of the file I am executing eventhough I don't plan to pass it any arguments?? - alfredo jahn -------------------------------//---------------------------------------- Alfredo Jahn V // UUCP: {texbell,digi}!ajahnv!alfredo 3208 Cole Ave., #1303 \\ // Internet: alfredo@ajahnv.lonestar.org Dallas, TX 75204 \X/ Voice: (214) 855-1316 -------------------------------------------------------------------------