Path: utzoo!attcan!uunet!cs.utexas.edu!yale!bunker!wtm
From: UD008160@NDSUVM1.BITNET (Elmer Morlock)
Newsgroups: misc.handicap
Subject: Help with GP-Echo synthesizer
Message-ID: <12607@bunker.UUCP>
Date: 3 Jul 90 20:17:18 GMT
Sender: wtm@bunker.UUCP
Reply-To: UD008160@NDSUVM1.BITNET (Elmer Morlock)
Distribution: misc
Lines: 28
Approved: wtm@bunker.UUCP
Fidonet: Blinktalk

Index Number: 9022

I am ttrying to get my GP-Echo synthesizer workin
serially with the Enable-4 (a shareware speech proram).
The GP-Echo synthesizer is not made any more.  I had a
specail serial cable made for it base on the specs in
the manual that came with it.  There is also an addemdum
sheet that came with it showin the eight switch settins.
I want it to run at 9600 baud.  The switches when toward
the front of the unit is then ON.  Switch one is startin
from the left going right.  Switches one, two, and three
are on.  Switch four is off.  Switch five is on.
Switches six and seven are on.  Switch 8 is off which
means serial.

This does not work and I have tried all other
possibilities.  Any ideas what I'm doing wrong.

United States mail address:
Elmer Morlock
box 8218
computer center
University of North Dakota
Grand forks Nd 58202
office phone:  (701) 777-3786

bitnet address: ud008160 at ndsuvm1
internet address: ud008160 at vm1.nodak.edu