Path: utzoo!attcan!uunet!seismo!dimacs.rutgers.edu!mips!daver!bungi.com!news
From: root (Admin)
Newsgroups: comp.sys.nsc.32k
Subject: Gatewayed mail message
Message-ID: <m0hpjzI-0000N5C@daver.bungi.com>
Date: 11 Jul 90 16:32:00 GMT
Sender: news@daver.bungi.com
Lines: 21
Approved: news@daver.bungi.com

questions
as I assemble my board.

1) The resistor Sips - normally orientation is important, but since each
    sip has 4 identical resistors, does it matter?  Should the dot on the
    pak be oriented with the arrow on the board?

2)  The 20 and 50mhz crystals - Do they get soldered on the board, or
    should there be sockets like the board mask shows?

3)  The 3 diodes, the arrow on the board, matches the black tail
    end of each diode for direction?

4)  The 4 leds, is the short leg the positive lead or the long one?

5)  These 50 odd same tantalum capacitors, no orientation right?
    (A5E104M, top 931ZC bottom), yet why does George's diagram  show
    +v on left, vertical +v towards bottom?

All help would be appreciated  
Bob (heathkit) Von Borstel