Path: utzoo!attcan!uunet!seismo!dimacs.rutgers.edu!mips!decwrl!elroy.jpl.nasa.gov!usc!trwind!venice!ries
From: ries@venice.SEDD.TRW.COM (Marc Ries)
Newsgroups: comp.windows.ms
Subject: Problems with ATI "Win3 OEM Upgrade"
Message-ID: <659@venice.SEDD.TRW.COM>
Date: 11 Jul 90 15:38:03 GMT
Reply-To: ries@venice.sedd.trw.com (Marc Ries)
Organization: TRW Systems Engineering & Development Division, Redondo Beach, CA
Lines: 19
References:


  I finally received the the OEM Upgrade diskette directly form ATI,
  but after following their instructions to the letter (which isn't too
  hard:  run setup form DOS, indicate an OEM graphics driver and say
  which diskette), but I get a hung cpu and "division error" if I run
  "win /r" and I get tossed back to DOS after the Win3 logo in "win"
  mode.  ATI tech support couldn't offer any definitive solutions.

  I have a 256k ATI VGAWONDER+mouse card (interupt 3), a Logitech
  Scanman card (Int 5), an ALR PowerFlex with 386sx/20, Dos 3.30, Wind
  3.0, a Packard Bell VGA monitor (PS/2 Color Monitor clone) 
  and 5 megabytes of ram.

  The card works fine with such DOS graphics programs as GrafWorks 
  and works fine in the standard Win3 800x600x4 mode.  I tried adding a 
  "[display]" and "mode800x600x16=84" entry to win.ini (ala the sv800 
  driver problem) without success.

  Any ideas?