Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!sdd.hp.com!hplabs!hpda!hpcuhc!hpspcoi!dlow
From: dlow@hpspcoi.HP.COM (Danny Low)
Newsgroups: comp.sys.ibm.pc
Subject: Re: HELP PLEASE-SOUND BLASTER??
Message-ID: <1640129@hpspcoi.HP.COM>
Date: 12 Jul 90 16:45:23 GMT
References: <848@uncw.UUCP>
Organization: HP Lovecraft Division
Lines: 17

>Okay, I bought a sound board, and just before I put it in, I set the
>IRQ to 7.  This is because I have two COM ports, but I wasn't sure
>whether or not the SB would conflict with COM2.  When I run VOXKIT,
>I get an interrupt error, even though I installed the CT-VOICE.DRV.
>
>So what should I set the IRQ to and how do I get VOXKIT to work?

There are programs around that tell you what IRQ lines are in use
already. The simplest way is trial and error. Set an IRQ line
in the Sound Blaster card and see if Voxkit works. Since there
are not that many IRQ lines to begin with, this procedure does not take
much time. That's how I set up my card.

			   Danny Low
    "Question Authority and the Authorities will question You"
	   Valley of Hearts Delight, Silicon Valley
     HP SPCD   dlow%hpspcoi@hplabs.hp.com   ...!hplabs!hpspcoi!dlow