Path: utzoo!attcan!uunet!snorkelwacker!usc!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!xanth!xanth.cs.odu.edu!burtle
From: burtle@cs.odu.edu (William J Burtle)
Newsgroups: comp.sys.ibm.pc.hardware
Subject: Adding a reset switch
Message-ID: <BURTLE.90Jul17125130@buttercup.cs.odu.edu>
Date: 17 Jul 90 16:51:30 GMT
Sender: news@cs.odu.edu
Distribution: comp
Organization: Old Dominion University, Norfolk, VA
Lines: 19

Does anyone know how to add a reset switch to an AT-compatible?
I read something about a "Power Good" line, but I cannot figure
out which one it is; it is not labeled, and I do not have a 
technical reference for my machine.  (It is an ARC/286).  I already
put a normally-open momentary-contact button into the chasse, I just
need to wire it up on the inside.  The power supply has two connectors
into the mother-board.  (one is closer to the rear of the unit -- the
power good should be on this one?).  Each of the two connectors has 
(I think) six lines on it.  

Can someone help me out?  Please email me at: 

			burtle@cs.odu.edu

Thanks a lot,

		Bill Burtle
		Old Dominion University
		Norfolk, VA