Path: utzoo!attcan!uunet!zephyr.ens.tek.com!uw-beaver!uw-june!june.cs.washington.edu!robertb
From: robertb@june.cs.washington.edu (Robert Bedichek)
Newsgroups: comp.sys.mac.hardware
Subject: Do you know of a NuBUS prototype board with interface logic?
Message-ID: <12573@june.cs.washington.edu>
Date: 18 Jul 90 01:11:12 GMT
Sender: robertb@cs.washington.edu
Reply-To: robertb@june.cs.washington.edu (Robert Bedichek)
Organization: U of Washington, Computer Science, Seattle
Lines: 14

We are designing a NuBUS card here at UW to write 3-D splines into a
stereo Tektronix frame buffer.

We have NuBUS wire-wrap proto boards and we have the Texas Instruments
NuBUS interface chip set.  We were wondering if any enterprise company
out there has done the obvious and made a proto board with the TI chips
already on the board and wired up to the edge connector.

Has anyone used the TI chips in bus master mode?  Did you have any problems
with this?

Thanks for whatever help you can lend,

	Rob