Path: utzoo!attcan!uunet!mcsun!hp4nl!mhres!squirrel!jv From: jv@mh.nl (Johan Vromans) Newsgroups: comp.unix.ultrix Subject: Re: How to use uucp on a VAXstation 3100 via Telebit modem? Message-ID: <1990Jul13.212625.13697@squirrel.mh.nl> Date: 13 Jul 90 21:26:25 GMT References: <1990Jul12.004749.4579@watcgl.waterloo.edu> <13165@cbmvax.commodore.com> Sender: jv@squirrel.mh.nl (Johan Vromans) Reply-To: Johan Vromans Organization: Multihouse Automation, the Netherlands Lines: 36 In-Reply-To: jv@mh.nl's message of 13 Jul 90 05:13:52 GMT In article jv@mh.nl (Johan Vromans) writes: johan> I have connected a T2000 to the VS_SLU (/dev/tty02, standard johan> cable, pins 2,3,6,7,20 straight through). I changed johan> /usr/lib/uucp/addmodems to accept 9600 baud for a telebit, and johan> used /etc/uucpsetup to configure this line "shared". No changes johan> to /etc/modecap. johan> johan> I cannot get tip/cu to work to dial manually, but UUCP works johan> fine. I'm using this line for both dialin and dialout with johan> only one problem: the jobs apparently do not get a HANGUP when johan> the carrier drops. Fortunately uucico times out after a johan> while... I seem to have mistaken about the HANGUP - it works as it should. Jobs get killed when the carrier drops. These are the settings I use in the T2000: E0 F1 M1 Q0 T V1 X1 Version CA4.04 LIB:NDL S00=001 S01=000 S02=043 S03=013 S04=010 S05=008 S06=010 S07=040 S08=002 S09=006 S10=007 S11=070 S12=050 S41=000 S45=000 S47=004 S48=000 S49=000 S50=000 S51=255 S52=000 S53=002 S54=000 S55=000 S56=017 S57=019 S58=000 S59=000 S60=000 S61=045 S62=003 S63=001 S64=000 S65=000 S66=001 S67=000 S68=255 S90=001 S91=000 S92=000 S95=000 S100=000 S101=000 S104=000 S110=255 S111=255 S112=001 S121=000 Johan -- Johan Vromans jv@mh.nl via internet backbones Multihouse Automatisering bv uucp: ..!{uunet,hp4nl}!mh.nl!jv Doesburgweg 7, 2803 PL Gouda, The Netherlands phone/fax: +31 1820 62911/62500 ------------------------ "Arms are made for hugging" -------------------------