Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!rutgers!cbmvax!eric
From: eric@cbmvax.commodore.com (Eric Cotton)
Newsgroups: comp.sys.amiga
Subject: Re: setclock question
Keywords: setclock
Message-ID: <13377@cbmvax.commodore.com>
Date: 23 Jul 90 21:22:18 GMT
References: <12853@sun.udel.edu>
Reply-To: eric@cbmvax (Eric Cotton)
Organization: Commodore, West Chester, PA
Lines: 16

In article <12853@sun.udel.edu> jon@sun.udel.edu (Jonathan R Deutsch) writes:
>Why is it when I use the setclock opt load command on some of my disks,
>I get an "unknown command date" error message?
>Is there something that needs to be on the disk for setclock to operate 
>correctly?
>Any info appreciated.

As I recall, the SetClock command executes the Date command after performing
the load or save.  It sounds like SetClock cannot find the Date command.
Is it missing from one of the disks you mention?  Does your path include
a directory where the Date command can be found (usually c:)?
-- 
Eric Cotton
Commodore-Amiga                                               (215) 431-9100
1200 Wilson Drive                        {uunet|pyramid|rutgers}!cbmvax!eric
West Chester, PA 19380            "I don't find this stuff amusing anymore."