Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!elroy.jpl.nasa.gov!ncar!ico!ism780c!darryl From: darryl@ism780c.isc.com (Darryl Richman) Newsgroups: comp.unix.i386 Subject: Re: ISC Installation problems partially solved Keywords: If this is unix, I think I'll go back to VIC20's. :-) Message-ID: <45632@ism780c.isc.com> Date: 25 Jul 90 23:22:43 GMT References: <871@augean.ua.OZ.AU> Reply-To: darryl@ism780c.UUCP (Darryl Richman) Organization: Interactive Systems Corp., Santa Monica CA Lines: 42 In article <871@augean.ua.OZ.AU> gvokalek@augean.ua.OZ.AU (George Vokalek) writes: "Problem: My hard disk has 1661 cylinders and ISC bombs if I try to " make the unix partition use cylinders above 1024, despite " the fact that it states explicitly that it can manage it. " " The error I was getting was: " " PANIC: athd_int never got non-busy, got 0x000000D1 " " This error would always occur during the construction of " /usr2 (or whichever file system crossed the 1024 boundard, " I presume). My disk is a 1661cyl x 53 sec/tk x 15 head " unit, with a WD1007V ESDI controller. The problem is that a 1007V looks just like a 1007A, but it reserves the last two cylinders on the disk, unlike the A. Sometimes trying to use the whole disk works out anyway, but usually reads work and writes on the last cylinder fail. The solution is, while installing, to not let Unix use the last two cylinders. This can be accomplished in one of three ways: - using the low level formatter on the 1007 and telling it to use a translated geometry - setting up the Unix partition so that it doesn't use the last two cylinders - not accepting the default disk parameters and decreasing the number of cylinders by 2. These work arounds should allow you to use the full extent of your disk, while providing the benefits of being able to map out bad sectors. We are working on a fix to the driver so that it can distinguish between the two controllers. --Darryl Richman -- Copyright (c) 1990 Darryl Richman The views expressed are the author's alone darryl@ism780c.isc.com INTERACTIVE Systems Corp.-A Kodak Company "For every problem, there is a solution that is simple, elegant, and wrong." -- H. L. Mencken