Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!know!zaphod.mps.ohio-state.edu!usc!apple!voder!pyramid!mikel From: mikel@pyrps5 (Mike Lipsie) Newsgroups: comp.windows.ms Subject: Re: COM3, modem, and 386 enhanced mode Message-ID: <120534@pyramid.pyramid.com> Date: 20 Jul 90 14:30:23 GMT Sender: news@pyramid.pyramid.com Reply-To: mikel@pyrps5.pyramid.com (Mike Lipsie) Organization: Pyramid Technology Corp., Mountain View, CA Lines: 41 In article <118500045@uxa.cso.uiuc.edu> mms00786@uxa.cso.uiuc.edu writes: > >I posted a note on my experiences with getting win3 to work with Com3 and Com4. >Basically, you need the following steps: > > a) Use the 34install program (I hope there's only one we are all talking > about) so that the net effect of running this program is to put the > address of com3 and com4 into locations 40:4 and 40:6. There seem to > be a few popular addresses - com3 = 3e8h and com4 = 2e8h (which are > not the Windows default) worked for me. I run DOS 3.3. I did not need to run any such program. It might be necessary in early version of DOS but 3.3 has COM3 and COM4. > > b) Modify your system.ini to include the lines > Com3Base=3e8h > Com4Base=2e8h > (using the addresses used with 34install, obviously) It is NOT NOT NOT the address used with the 34install. It is the address that your modem is looking for. If you do need 34install, enter the addresses that your modem documentation gives. BTW, this step (modifying Com3Base) was the critical one for my getting the modem to work. > > c) Look in your win.ini file. If you had a modem when you setup windows, you > will find a line like Modem=ComX,T,3. Modify X so that it is the com port > on which you have the modem. On my system it was already Com3. The problem was the ",T,3" was missing. This line is in the [Terminal] section of WIN.INI. Good luck. ----------- Mike Lipsie mikel@pyramid.com Pyramid Technology Corp, Mountain View, CA +1 415 335 8657 "Toto kansasoseum non est cognito" -- Phil Frank