Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!cs.utexas.edu!samsung!munnari.oz.au!bruce!trlluna!rhea.trl.oz.au!aduncan From: aduncan@rhea.trl.oz.au (Allan Duncan) Newsgroups: comp.sys.amiga Subject: Re: VD0: problems Message-ID: <1998@trlluna.trl.oz> Date: 2 Aug 90 00:15:05 GMT References: Sender: root@trlluna.trl.oz Lines: 20 From article , by ked01@ccc.amdahl.com (Kim DeVaughn): > Is this under 2.0? I have heard vd0: doesn't work under it. Can anyone > confirm/deny this? And what about ASDG's FaccII ... is it OK under 2.0? > > Perry? Anyone? I've used VD0: on 2.0. I found that it interacts with the delayed screen/window opening of 2.0, but otherwise works fine (RAD: doesn't survive the reboot, the docos say). This just means that you have to delay firing it up until after iprefs is run, so I can't pull my favourite stunt of removing RAM: and then assigning RAM: to VD0:! I'm not sure which version of VD0: it is - the original or the non-Perry assembler mod - I will chase it up in due course. This was on a 2000 using the kickit method. Allan Duncan ACSnet a.duncan@trl.oz (03) 541 6708 ARPA a.duncan%trl.oz.au@uunet.uu.net UUCP {uunet,hplabs,ukc}!munnari!trl.oz.au!a.duncan Telecom Research Labs, PO Box 249, Clayton, Victoria, 3168, Australia.