Path: utzoo!attcan!uunet!cs.utexas.edu!lgc.lgc.com!usenet
From: max@maxsun.lgc.com (Max Heffler)
Newsgroups: comp.sys.apple2
Subject: SCSI problems
Keywords: Maxtor 8760 760M drive not seen by High Speed SCSI/system 5.0.2 util
Message-ID: <1990Jul28.233501.16766@lgc.com>
Date: 28 Jul 90 23:35:01 GMT
Sender: max@lgc.com
Organization: Landmark Graphics Corp., Houston, Tx
Lines: 15

I attached a MAxtor 8760 760M drive to my High Speed SCSI board and it is
not being seen by the utilities that came with it, or the 5.0.2 System Disk.
The SCSI board is device 7 and the Maxtor is device 6 with terminator.
I read about Mac SCSI not being standard with regard to unit attention on
power up, interrupts, and termination.  I don't know if the GS has the same
problems.  Is anyone successfully using a generic standard SCSI device with
the Apple High Speed SCSI card?  Do I have to do anything special (jumpers)?
What about low-level formatting?  Why is my Maxtor invisible to either of
these utilites?
Thanx in advance...
--
Max Heffler			internet: max@lgc.com
Landmark Graphics Corp.		uucp: ..!uunet!lgc!max
333 Cypress Run, Suite 100      phone: (713) 579-4751
Houston, Texas  77094