Path: utzoo!attcan!uunet!cs.utexas.edu!yale!umich!sharkey!dino!hascall From: hascall@cs.iastate.edu (John Hascall) Newsgroups: comp.unix.ultrix Subject: Re: LPS20 PostScript Extensions Message-ID: <2363@dino.cs.iastate.edu> Date: 30 Jul 90 15:12:40 GMT References: <2344@dino.cs.iastate.edu> Sender: usenet@dino.cs.iastate.edu Organization: Project Vincent, Iowa State University Computation Center Lines: 26 stergios@jessica.stanford.edu writes: }I (John) write: }I have a "PostScript Extensions" chapter in the "PrinterServer }Client for ULTRIX Users Guide" under Programmer's Supplement. Hmmm, I don't recall seeing this in mine, (but then mine was just printed-off at the local DEC office), but I will RTFM again -- I was rather expecting a separate manual describing all of the extensions like we got with all of our LN03r's (if there is in fact such a manual for the LPS20 I would greatly appreciate the order #). }for "output stacking" I assume you mean tray selection.... }my lps40, which is very close to an lps20 except for double sided }printing. No, in addition to duplexing, the LPS20 can offset-stack the jobs in the main output trays (so they are easier to separate -- that is, one job comes out, then the rollers shift sideways about a half-inch so the next job is not exactly on top of the previous one). This is what I am trying to discover how to do. Thanks all, John Hascall john@iastate.edu hascall@atanasoff.cs.iastate.edu