Path: utzoo!attcan!uunet!cs.utexas.edu!samsung!zaphod.mps.ohio-state.edu!uwm.edu!bionet!ucselx!petunia!news
From: jburch@polyslo.CalPoly.EDU (Jerry Burch)
Newsgroups: sci.electronics
Subject: Termination of TTL <-> TTL cable
Message-ID: <26b48046.147d@petunia.CalPoly.EDU>
Date: 30 Jul 90 18:45:26 GMT
Reply-To: jburch@polyslo.CalPoly.EDU (Jerry Burch)
Distribution: na
Organization: Cal Poly State Univ,CSC Dept,San Luis Obispo,CA 93407
Lines: 21



I am working on a project which needs to communicate over a ten foot cable
with TTL gates on either end. Simply connecting the outputs on one end to
the inputs on the other end has resulted in glitches on some signal lines
when others switch. Is there a proper method to terminate such a cable?

Preferably this would only involve one end of the cable as the other is off
of a port on a micro which uses a pair of LSTTL gates as buffers.

Any suggestions would be appreciated.

Jerry Burch
jburch@polyslo.calpoly.edu


-- 

+----------------------+------------------------------------+
|     Jerry Burch      |     jburch@polyslo.CalPoly.EDU     | 
+----------------------+------------------------------------+