Path: utzoo!utgpu!news-server.csri.toronto.edu!clyde.concordia.ca!uunet!mcsun!ukc!reading!borage!bje
From: bje@borage.cs.reading.ac.uk (Barry J. Evans)
Newsgroups: comp.sys.transputer
Subject: Meiko, tdb
Message-ID: <2738@onion.reading.ac.uk>
Date: 9 Aug 90 09:33:08 GMT
Sender: news@reading.ac.uk
Reply-To: bje@csleaf.cs.reading.ac.uk (Barry J. Evans)
Organization: Comp. Sci. Dept., Reading Univ., UK.
Lines: 19


 I have been using the 'tdb' command with a PAR file on our Meiko Computing
Surface recently.  Below is the example

par
        processor 0 test -s 5
        processor 1 test 5
endpar

 The programs are written in 'C' and use the CStools to communicate. I can only
monitor one program at once by using tdb. The documantation suggests that it is
possible to run one tdb per transputer, i.e. can monitor both of my programs
communicating with each other on two tdb's. I can not seem to get this to work.

 Could anybody who has come across this please cast some light on it. Is it
possible ? If so how ?

Thanks 
Barry Evans