Path: utzoo!censor!geac!torsqnt!news-server.csri.toronto.edu!mailrus!wuarchive!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!aplcen!haven!adm!smoke!timg
From: timg@smoke.BRL.MIL (Timothy Gion)
Newsgroups: comp.dcom.modems
Subject: out of sync error with Ymodem-G
Message-ID: <13543@smoke.BRL.MIL>
Date: 13 Aug 90 11:59:52 GMT
Organization: U.S. Army Ballistic Research Laboratory, APG, MD.
Lines: 20


I recently tried to receive a file using DSZ's Ymodem-G with my Practical
Peripherals 2400 MNP5 from an USR HST.  I have never been able to use 
Ymodem-G, but this is the first time I tried a transfer using DSZ.  I 
usually use Telix which just says transfer aborted.  DSZ gave me 
"out of synce error:  11 should have been 6".  The '11' kept incrementing 
until the transfer aborted.  I'm pretty certain that the problem is in my
serial port because I was hit by a surge that fried parts of my expansion 
bus and most likely my serial port.  I would like to know exactly what is
damamged in my serial port.  In case there isn't anything wrong with my 
serial port, here is my init string:
 
    "ATM1 Q0 V1 X4 M1 E0 \N3 \Q3 \G1 \J0 \V1"

It's possible that I may have forgot to list a few settings, but I've had no
problems using a locked baud rate of 9600.

--Tim
-- 
  **  The Mages' Guild :: (301)939-9139 :: 2400MNP5 :: WWIVLink @13124 **