Path: utzoo!utgpu!news-server.csri.toronto.edu!clyde.concordia.ca!s3!vaillan
From: vaillan@ireq.hydro.qc.ca (Clement Vaillancourt)
Newsgroups: comp.dcom.sys.cisco
Subject: Re: Cisco configuration to boot 3Com terminal servers across subnets
Message-ID: <2491@s3.ireq.hydro.qc.ca>
Date: 16 Aug 90 00:39:33 GMT
References: <2444@s3.ireq.hydro.qc.ca>
Sender: root@s3.ireq.hydro.qc.ca
Organization: ireq
Lines: 26

In article <2444@s3.ireq.hydro.qc.ca> vaillan@ireq.hydro.qc.ca () writes:
>I have a CS200 terminal server on one subnet and the NCS on the
>other subnet of my Cisco. My Cisco have two ethernet interfaces.
>
>How can I boot a CS200 terminal server running TCP/IP software
>from a NCS across subnets. Those were made by Bridge Communication now 3Com.
>
>Even if those two boxes run TCP, I think some XNS is involved at
>boot time. What configuration is required in the Cisco?
>

I tried routing XNS protocol between the ethernet interfaces in my
Cisco but that did not work; I used the Cisco Bridging Software on
the same Ethernet and this worked.

Thanks to:
JOHN@heap.cisco.com 
jzs@bridge2.ESD.3Com.COM
sung@mcnc.org

Clem.
--
   Clement Vaillancourt,             |   Institut de Recherche d'Hydro-Quebec
   Network Manager                   |        1800 Montee Ste-Julie, Varennes
                                     |             P. Quebec, Canada, J3X 1S1
   Email: vaillan@ireq.hydro.qc.ca   |  Tel: 514-652-8238 / Fax: 514-652-8309