Path: utzoo!attcan!uunet!samsung!zaphod.mps.ohio-state.edu!sdd.hp.com!decwrl!ucbvax!RICHTER.MIT.EDU!krowitz
From: krowitz@RICHTER.MIT.EDU (David Krowitz)
Newsgroups: comp.sys.apollo
Subject: DSP90 shutdown?
Message-ID: <9008141319.AA01043@richter.mit.edu>
Date: 14 Aug 90 13:19:36 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 20

We bought a used DSP90 to replace our DSP80, and of course we
did not get the "using your DSP90 ..." book since the box was
used. I've been able to figure out that on the DSP90 I must 
push both the reset buttons at once in order to reset the
node, but I have not been able to get the shutdown button
to work. I press it and nothing happens. When I press both
of the reset buttons, then the light above the shutdown button
comes on briefly before the DSP90 starts its diagnostic
sequence and the salvol of the boot volume. Could someone
run through their DSP90 handbook and tell me if our shutdown
button is broken, or whether I'm just misusing it? (we're
running SR9.7 on a DSP90-3MB with two MSD-500M disks).


 -- David Krowitz

krowitz@richter.mit.edu   (18.83.0.109)
krowitz%richter.mit.edu@eddie.mit.edu
krowitz%richter.mit.edu@mitvma.bitnet
(in order of decreasing preference)