Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!usc!jarthur!nntp-server.caltech.edu!tybalt.caltech.edu!toddpw
From: toddpw@tybalt.caltech.edu (Todd P. Whitesel)
Newsgroups: comp.sys.apple2
Subject: Re: How do I get kermit to go faster than 2400 baud
Keywords: IIGS, TWGS, Telebit Trailblazer, Kermit
Message-ID: <1990Aug13.212155.29044@laguna.ccsf.caltech.edu>
Date: 13 Aug 90 21:21:55 GMT
References: <1990Aug13.135356.11691@lgc.com>
Sender: news@laguna.ccsf.caltech.edu
Organization: California Institute of Technology
Lines: 15

max@maxsun.lgc.com (Max Heffler) writes:

>I am using an Apple IIGS with a Transwarp GA and a Telebit Trailblazer plus
>modem to connect to another telebit at the office.  When the connection was
>made at 19200 baud on both ends, the Telebit responded with Fast Connect
>implying that I had a 19200 baud connection; however, the throughput I
>measured under kermit was only around 2400 Baud.  Does anyone know how to
>transmit at a faster rate with kermit, or possibly some other comm. program?

Kermit 3.86 can handle 9600 (through a Super Serial Card and through the GS's
modem port) without too much trouble. I'd check your control panel settings --
make sure THEY are set to 19200.

Todd Whitesel
toddpw @ tybalt.caltech.edu