Path: utzoo!attcan!utgpu!news-server.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!zaphod.mps.ohio-state.edu!samsung!uunet!cs.dal.ca!morash
From: morash@ug.cs.dal.ca (Dave Morash)
Newsgroups: comp.sys.ibm.pc.hardware
Subject: Problems adding a second hard disk
Message-ID: <1990Aug19.153005.7306@ug.cs.dal.ca>
Date: 19 Aug 90 15:30:05 GMT
Distribution: na
Organization: Math, Stats & CS, Dalhousie University, Halifax, NS, Canada
Lines: 21



	I recently tried to install a second hard drive into a PC clone
with a 286 speed up board in it. The machine has an ST225 already installed,
with a WD10025-WX2 controller. The second hard drive is a Mountain 
model RD-4255 Model III.

	The problem is that the machine won't recognize the hard drives
when booting. I removed the resistor pack from the ST225, and I looked the
Mountain drive over for any jumpers and such but I didn't see any on it.

	What else needs to be done to get the machine to recognize both 
drives? (There's no CMOS, what about jumpers on the controller?)

	Any thnaks would be appreciated.

-- 
"Locked in a time warp of their very | morash@ug.cs.dal.ca
own Charged GBH are carrying on the  | morash%dalcsug%dalcs@watmath.uucp
dubious traditions of buzzsaw guitar | morash%dalcsug@dalcs.uucp
and gobbin' on audiences."