Xref: utzoo comp.emacs:8950 gnu.emacs:3640 Path: utzoo!utgpu!news-server.csri.toronto.edu!clyde.concordia.ca!uunet!mcsun!unido!tub!tubopal!opal!bsp09 From: bsp09@audrey.cs.tu-berlin.de (Uebung bsp) Newsgroups: comp.emacs,gnu.emacs Subject: Re: GNU Emacs 18.54 not displaying properly on Radio Shack Model 100 Message-ID: Date: 25 Aug 90 21:04:37 GMT References: <5145@uafhp.uark.edu> Sender: news@tubopal.UUCP Reply-To: nickelsen@mikroperipherik.e-technik.tu-berlin.dbp.de Followup-To: poster Organization: Technical University of Berlin Lines: 31 In-reply-to: shadow@uafhp.uark.edu's message of 25 Aug 90 17:41:59 GMT To: In article <5145@uafhp.uark.edu> shadow@uafhp.uark.edu (Kyoki-san) writes: I know you think it's funny, but I have got GNU Emacs 18.54 99% working using my Model 100 as the display. I have only two problems, I think: 1) All lines are overwriting each other. I.e. I get carriage-returns, but no linefeeds. 2) The status line is getting a "D" at the beginning of the line instead of being displayed in reverse video. My Problem is similar: Using a 386-PC with Interactive 386ix 3.2 and GNU Emacs 18.55 I do NOT have problem no. 1) (as above), but problem no. 2), if the console (terminal at386) is used. All other screen-oriented programs I tested are running well. (Nethack, vi (of course!), user interface of a mailbox, MicroEmacs 3.9, etc.). Inverse video used by these programs is correct. I made one patch to the Emacs source: In sysdep.c I #undef'ed TIOCGETC after #including . this was necessary because termio.h defines TIOCGETC, but omits a definition Emacs needs if TIOCGETC is defined. Any help is welcome, thanks in advance! Juergen -- ----------------- Juergen Nickelsen nickelsen@mikroperipherik.e-technik.tu-berlin.dbp.de